How to use autopot with the Greenhouse Feeding Bioline

There are 3 methods for the Bioline + autopot:

Method 1:

1- Prepare your autopot system: We advise to use peat based substrate with the Bioline. Prepare the mix of lightmix + perlite (30%). Adding wormcast is a plus (10%). Add the Biogrow, 3 to 5 gr/L. Mix well the mixture. 

Make sure the system is well connected and water flow easly. Install the air dome correctly (if you have it) and make sure it is working before adding your substrate. Add enough clay pebbles at the bottom of the pot.

As you use peat based buffered substrate, you don't need to PH your water. 

2- Plant the seedling/clone, make a good watering with the Enhancer (1gr/L water) BUT DON'T START THE SYSTEM RIGHT AWAY !  Make at least 3 hand watering before starting the system, the plants need to establish the roots in the pot. A

After this period (between7/10days) the system can be turn on ! 

3- After 10/12 days, stop the system and let the substrate dry (usually in 2 days), then make a good hand watering with Enhancer (1gr/L water) and start again the system.

Repeat every 12/15 days

4- Flowering: after 30/45 days of veg, you can switch to 12/12.

After 7/10 days, stop the system, let the substrate dry, then top dress Biobloom, mix it in the first layer of the soil and make a good watering with Enhancer. Make 2 hand watering to insure the diffusion of the Biobloom in the substrate. Then start again the system. 

5 - After 10/12 days, stop the system and let the substrate dry (usually in 2 days), then make a good hand watering with Enhancer (1gr/L water) and start again the system.

Repeat every 12/15 days

6 - Few days before harvest, switch off the system, let it dry and harvest !