Autopot with mineral line: 

Using autopot with our mineral line is very easy ! 

1- Prepare your autopot system: fill the pot with a mix of the susbstrate of your choice (peat, coco, rockwool) make sure you add enough perlite (or clay pebbles) in the substrate to drain efficiently (30/40%) . Make sure the system is well connected and water flow easly. Install the air dome correctly (if you have it) and make sure it is working before adding your substrate. Add enough clay pebbles at the bottom of the pot.

2- Place your seedling or clone in the pot BUT DON"T START THE SYSTEM RIGHT AWAY !!!! LET THE PLANT ESTABLISH HIS ROOTS IN THE POT BEFORE THAT !!

3- After the plant establish the root system in the pot, you can prepare your fertilizer solution and start the system.

Add the water in the tank

Add Calcium or Calmag if you use soft water and/or substrate with low calcium content, use an EC meter to insure you add the right amount.

Add the base fertiliser, use an EC meter to ensure you add the right amount. 

Add the PH up or down if you use coco or rockwool. If you use peat based substrate, it will buffer the fertilizer solution to the PH mention on the packaging. 

4- Start the system ! 

5- Check regularly the PH in the tank to make sure it is not switching. If it is the case re-adjust it. 

6- Don't let the fertilizer solution stand more than 10 days, make sure you empty the tank within this time.

It is also good to let the substrate dry every 10/15 days, it can be used to add extra biostimulant/product that will improve nutrient uptake or substrate condition. Then, start again the system. 

You can find the instruction from autopot here: Autopot Userguide